CT5000S
Cut panels, strips and blocks in series

The CT5000S works with a cutting gang of two cutting units. The first unit has horizontally arranged cutting wires, the second directly behind it has vertically arranged cutting wires.

This cuts the material horizontally and vertically to the desired dimensions in one pass. Up to 60 cutting wires can be used in total. The split between the horizontal and vertical cutting unit can be chosen freely.

The process is simple: the material is transported through the cutting gang on two conveyor belts – one in front of and one behind the cutting unit – cut there horizontally and vertically, and discharged finished on the outfeed side.

Conveyor speed and wire temperature can be adjusted at any time to the material and cutting task.

On the CT5000S the cutting wires are set and hung manually. For each job the wires are set to the required dimensions.

If, for example, panels, strips or blocks are to be produced in certain sizes, the horizontal and vertical wires are rehung and reset accordingly.

The number and distribution of the cutting wires between the horizontal and vertical cutting unit can be freely adapted to the respective job.

The CT5000S is therefore mainly intended for larger quantities with the same dimensions. Setting up and rehanging the cutting wires takes time. Once the machine is set up, large quantities of identical cuts can then be produced continuously.

Infeed and outfeed roller conveyors

Additional infeed and outfeed roller conveyors are available for the CT5000S. Especially on the outfeed side, this creates a practical buffer zone for the finished cut parts.

The machine can keep producing while the already cut parts are collected on the roller conveyor and then removed. This means the material flow does not have to be interrupted after every cut.

Mobile roller conveyor tables are also possible as an option. The finished parts run directly onto the mobile roller conveyor table. This can then be pushed away from the machine and replaced by a second roller conveyor table.

Finished cuts can thus be moved out of the production area while the machine keeps working.

Side walls for panels and small cuts

The CT5000S can optionally be equipped with side walls. They guide standing panels through the machine during transport and prevent them from tipping over.

At the same time, with very small cuts the side walls prevent small blocks from falling off the side of the table.

Questions about operation, adjustment or troubleshooting can be clarified directly with our technical support.

Spare and wear parts such as cutting wire and springs can be obtained directly from cnc-multitool. Many components are easily accessible and can be replaced by the customer.